Closed

Horizontal and vertical divisor coefficients

Proposition. (Horizontal and vertical divisor coefficients). Assume the height-one DVR hypotheses given above also for the horizontal prime divisors. Then, as codimension-one cycles on X\mathcal X with rational coefficients, 1e0cyc⁡(div⁡X(s⊗e0))=cyc⁡(div⁡X(s))‾+∑VcVe0[V].\begin{equation} \frac1{e_0}\operatorname{cyc}\bigl(\operatorname{div}_{\mathcal X}(s^{\otimes e_0})\bigr) =\overline{\operatorname{cyc}(\operatorname{div}_X(s))} +\sum_V\frac{c_V}{e_0}[V]. \end{equation} Here the bar means coefficientwise closure of the horizontal prime cycles. At any height-one point with DVR AA, a local coefficient f=a/b∈Frac⁡(A)×f=a/b\in\operatorname{Frac}(A)^\times, a,b∈A∖{0}a,b\in A\setminus\{0\}, has order ord⁡A(f)=length⁡A(A/aA)−length⁡A(A/bA).\begin{equation} \operatorname{ord}_A(f)=\operatorname{length}_A(A/aA)-\operatorname{length}_A(A/bA). \end{equation} For an effective local equation ff, its coefficient is length⁡A(A/fA)\operatorname{length}_A(A/fA), using the actual quotient, including its nilpotents. This is algebraic Cartier-to-cycle compatibility; it does not identify an analytic current or an F8 tropical end cycle.

Proof

Proof. If tt is a uniformizer and a=tmua=t^m u with uu a unit, the chain of powers of tt in A/(tm)A/(t^m) has mm simple quotients, each its residue field. Thus length⁡A(A/aA)=m\operatorname{length}_A(A/aA)=m; a unit has quotient zero and length zero. Subtracting the two orders proves (I.0.6), independently of the chosen fraction. In particular replacing A/(tm)A/(t^m) by its reduction would incorrectly replace mm by one when m>0m>0.

A height-one prime of X\mathcal X is either a vertical component VV or horizontal. For a horizontal prime HH, the element π\pi is already a unit in OX,ηH\mathcal O_{\mathcal X,\eta_H}. Localizing the model to its generic fibre therefore leaves this DVR unchanged. If HKH_K is the corresponding prime divisor of XX, the local coefficient of s⊗e0s^{\otimes e_0} has order e0ord⁡HK(s)e_0\operatorname{ord}_{H_K}(s). At VV its order is cVc_V by definition. Comparing these coefficients proves (I.0.5).

There is no special-fibre factor bVb_V in a horizontal coefficient. For a finite residue extension, a simple residue-field factor has length its full field dimension after restriction of scalars; this is exactly the convention in NAG-002543 and NAG-002552. It counts inseparable degrees as well as separable degrees, without counting embeddings. ◻

Citation

Non-Archimedean Geometry Foundations, Tag NAG-002834.

Proof in chapter · Fixed-edition record