Closed

Common domination and the uniformizer test

Proposition. (Common domination and the uniformizer test). Assume the four interface properties for all cycles and operations below. Let p:Y→Xp:\mathcal Y\to\mathcal X be a proper common-generic-fibre domination with p∗[Y]=[X]p_*[\mathcal Y]=[\mathcal X]. Let DiD_i be model pseudo-divisors with lines extending Li⊗eiL_i^{\otimes e_i} and specified sections si⊗eis_i^{\otimes e_i}, 0≤i≤d0\leq i\leq d. Suppose only that ⋂i=0d∣Di∣∩X=∅.\begin{equation} \bigcap_{i=0}^d |D_i|\cap X=\varnothing. \end{equation} No pairwise or intermediate proper intersection is required. With E0=∏i=0deiE_0=\prod_{i=0}^d e_i, define the supported model value by JX(D0,…,Dd)=λE0deg⁡k(D0⋯Dd⋅[X]).J_{\mathcal X}(D_0,\ldots,D_d) =\frac{\lambda}{E_0}\deg_k(D_0\cdots D_d\cdot[\mathcal X]). Then it is symmetric and JY(p∗D0,…,p∗Dd)=JX(D0,…,Dd).\begin{equation} J_{\mathcal Y}(p^*D_0,\ldots,p^*D_d) =J_{\mathcal X}(D_0,\ldots,D_d). \end{equation} Hence two model presentations have equal values if their divisor data pull back compatibly to a common domination satisfying the same properties. This requires the actual pulled-back lines, sections and supports, not just their generic line-bundle classes.

Replacing sis_i by πsi\pi s_i at a fixed metric gives ΔJ=+λ∏j≠iej∑VbVdeg⁡(Lj∣V)j≠i,k(V).\begin{equation} \Delta J=+\frac{\lambda}{\prod_{j\ne i}e_j} \sum_V b_V\deg_{(\mathcal L_j|_V)_{j\ne i},k}(V). \end{equation} This equals +λ+\lambda times the corresponding model-measure mass. It is +λ+\lambda times the generic degree only when the relevant specialization-of-degree identity has also been established.

Proof

Proof. The support after all d+1d+1 operations lies in ⋂i∣Di∣\bigcap_i|D_i|. By (C.1.45) this is vertical, so the degree in the definition is available, even when the total support has positive dimension. The operations produce a zero-dimensional class there. Their commutativity proves symmetry. Iterating the second property gives p∗(p∗D0⋯p∗Dd⋅[Y])=D0⋯Dd⋅p∗[Y]=D0⋯Dd⋅[X].p_*\bigl(p^*D_0\cdots p^*D_d\cdot[\mathcal Y]\bigr) =D_0\cdots D_d\cdot p_*[\mathcal Y] =D_0\cdots D_d\cdot[\mathcal X]. The retained vertical degree and identical root exponents prove (C.1.46). Applying this equality to each side of a common domination proves the next assertion. This proof does not manufacture the supported operators or their projection formula.

The model divisor changes by eidiv⁡(π)e_i\operatorname{div}(\pi) when sis_i is multiplied by π\pi. Additivity, commutativity and the third property turn the change in the final class into ei∑VbV(∏j≠ic1(Lj∣V))[V].e_i\sum_V b_V\left(\prod_{j\ne i}c_1(\mathcal L_j|_V)\right)[V]. Taking its degree and dividing by E0/λE_0/\lambda proves (C.1.47). The generic support condition is unchanged; the model support is enlarged by the special fibre when needed. On a model with only the standard projective component and degrees mjm_j, this gives +λ∏j≠imj+\lambda\prod_{j\ne i}m_j, as required by the point normalization. The blowup computation gives the same mass for pulled-back data, so it is also a common-model regression test. ◻

Citation

Non-Archimedean Geometry Foundations, Tag NAG-003054.

Proof in chapter · Fixed-edition record